Globber One K E-Motion S10 – Electric Blue

Your E-10 Scooter has a kick-start function. To start, place your foot directly on the accelerator pressure sensor, push your scooter to reach a speed of 5km/h. The battery lights signal on the deck will turn on and you are now in the “ON” mode

The accelerator pressure sensor at the front of the deck allows you to intuitively control your speed. Your E10 will turn off automatically after 1 minute of inactivity

Dual-brake system; mechanical rear brake and E-ABS braking system (activated when pressing down on the rear brake) for safe stops.

100% Rubber rear 5″ hub wheel (150w hub motor integrated) delivers puncture-free rides & maximum shock absorption.

Sturdy aluminum structure with a wide, anti-slip deck design supports up to 50kg.

For all replacement and new parts please visit www.globberparts.com

For warranty issues or general inquires please email Parts@Globber.com.

Battery Getting Started & Storage

To optimize the performances and lifetime of your electric scooter battery, fully charge the battery before using it for the first time.  The first charge takes approximately 4 hours and up to 3 hours for recharges and fully charge the battery once a month. 

To charge the battery remove the waterproof cap from the port and plug in the charge.

Plug the charger into a suitable power source.

When LED on the charger is RED, the battery is charging.

When it switches to GREEN, charging is complete and ready to ride.

Stop charging when the LED turns green; charging the battery for too long will reduce its lifetime.

Do not switch on the scooter during charging.

Only use the charger supplied with your electric scooter.

To guarantee the battery lifetime, charge it when its level is low.  If it is not used for a long period of time, you are advised to charge it once a month.

The recommended storage temperature for the battery is between 5C and 30C.

SHIPPING NOTE: this item ships in the packaging shown without an over box, item will be visible upon delivery.